Skip to content
Athena User Guide
Esc
↑↓navigate↵open⌘Jpreview
On this page

Secure your account

Set a strong password and protect your organizer account with two-factor authentication.

Everything in this guide lives on the Settings page; open it from the gear icon in the dashboard sidebar’s footer, next to Sign out. The page covers account security and email verification, in three sections: Account, Password, and Authenticator app.

Verify your email

The Account section shows your email with a Verified or Unverified pill. If you’re unverified, click Resend verification email and open the link Athena sends you; email/password sign-in requires a verified address.

Change your password

In the Password section, fill in Current password, New password, and Confirm new password (at least 8 characters), then click Update password. Changing your password signs you out everywhere else: every other session is revoked.

If you’ve forgotten your password, use the Reset password page linked from the sign-in form. Athena emails you a reset link if an account exists for the address you enter.

Set a password on a Google or GitHub account

If you signed up with Continue with Google or Continue with GitHub, your account has no password yet, and the Password section says so: “This account was created without a password. Set one to enable password-based sign-in and two-factor authentication.”

Enter and confirm a password (at least 8 characters) and click Set password. From then on you can sign in with email and password too, and you’re eligible for two-factor authentication.

Turn on two-factor authentication

Two-factor authentication (2FA) asks for a code from an authenticator app (Google Authenticator, 1Password, or similar) on top of your password at sign-in. Your account needs a password first; without one, the section shows “Two-factor authentication cannot be enabled until this account has a password.”

In the Authenticator app section:

  1. Enter your password and click Set up authenticator.
  2. Scan the QR code with your authenticator app.
  3. Athena also shows a set of Backup codes below the QR code. That is the only time this set is displayed, so save them somewhere safe. You can mint a fresh set at any time from the Backup codes section of Settings, which invalidates the previous ones.
  4. Enter the 6-digit code from your app and click Confirm and enable 2FA. If the code is rejected (“That code is not valid. Please try again.”), wait for your app to show a fresh one and retry.

When it’s active, the section reads Two-factor authentication is on.

Sign in with 2FA enabled

After you enter your password, Athena asks for your Authentication code. The Trust this device toggle (on by default) remembers the browser you’re on, so it won’t ask for a code again on that device.

Turn off two-factor authentication

In the Authenticator app section, enter your password and click Turn off two-step verification. Your password alone signs you in again afterwards.

Was this page helpful?